HIGH SPEED MILLING MACHINE
TYPE: RXP 500 DSC

BASE MACHINE:

1. Intel Pentium based Roeders High Speed CNC Control RMS6

2. Machine work-piece table (type RXP500DSC):
Table: Machine table (7.8” diameter). X-axis integrated turn and swivel table, special direct drive torque motor rotary drives with stiffness and precision.

Swiveling range (A-axis): +/- 110, max speed: 40rpm
Turning range (C-axis): 360 max speed: 80rpm

3. Laser tool length measuring device:
For automatic tool length, diameter, custom taper and contour measurement with breakage control.

Fully integrated into RMS6 control, safely hidden in sealed tool changer compartment.

4. Automatic tool cleaning station:
Compressed air-blast cleaning of the cutting tool before laser measurement.

Tool moves to the cleaning station automatically when the CLEAN cycle is programmed.

5. Oil mist spray cooling system:
Lubricates tool with fine oil/air mist.

6. CD ROM Drive

7. Software for re-cutting partial programs:
Fully integrated into the NC milling simulation program

8. Fischer 3,000 to 42,000 RPM spindle, type MFW1230/42
19 HP (14.0KW)

Maximum tool diameter 0.625 inches ((16mm)

Includes converter, hydraulic and oil/air lubrication

Fully integrated into machine control

Equipped for HSK E40 tool changer

9. Automatic tool changer – 19 positions:
Tool changer capacity for tools is 18 (one position is occupied by the Auto 3D Probe). Includes collision detection.

10. Ethernet network card:
100Mbps, Fiber-optic type of communication for minimal interference, RJ45 converter with 110V power connection.

11. NC milling simulation program:
Easy to use windows interface, runs directly on control

Allows the operator to see graphically the cutter paths in 3D

Features include: zoom, pan marking of the spline points, colored layout of feed rates, any viewing angle, DXF and HPGL interface, calculation of maximum travels.

12. 3-D Touch Probe (Automatic) for automatic work piece setup:
Reference pin included, fully integrated into control, data transmission via IR-Interface.

Extra Features:


1. Inductive Heat shrinking device RIS 2

2. Machine table with integrated Erowa ITS148 chuck

3. Donaldson DFT 2-4 vacuum system for graphite milling

4. Specialized Clamping Device

5. 3mm Tool Holder

6. Emulsion Cooling System-Dental Retrofit

This machine is listed for sale by located in Vancouver, British Columbia