Max Width Workpiece

8 inches

Max Roll Dia.

8 inches


8" x 8" STANDARD 2 HI NON REVERSING ROLLING MILL

MACHINE #14021

MANUFACTURER......................STANDARD MACHINE CORP. (USA)
TYPE..............................2 HIGH COLD ROLLING MILL
ROLL DIAMETER.....................8" (203MM)
ROLL WIDTH........................8" (203MM)
ROLL BEARING TYPE.................ROLLER BEARINGS
TYPE OF SCREWDOWN.................SINGLE HAND WHEEL
NON-REVERSING
DIRECTION OF TRAVEL...............RIGHT TO LEFT
DRIVE MOTOR.......................10 HP, 208 VOLTS, 3PH, 60 HZ.
DRIVE TRAIN.......................BELT DRIVE INTO HERRINGBONE GEAR
WINDOW WIDTH......................10" (254MM)
MILL STAND CROSS SECTION..........4" (101MM) x 7" (178MM)
BOTTOM ROLL IS DRIVEN FROM THE MOTOR AND GEARBOX
TOP ROLL IS DRIVEN FROM GEARS CONNECTED TO BOTTOM ROLL
CAN BE USED FOR FLAT STRIP OR FLAT WIRE
FOR FLAT WIRE MILL IS EQUIPPED WITH A 3 ROLL BENDER CASCADING THE WIRE AROUND
A NON-DRIVEN 12" (305MM) DIA. X 24" (610MM) WIDE DRUM.
TAKE-UP CAN BE REMOVED FOR FLAT STRIP ROLLING.
STOP-START OPERATOR BUTTONS ON BOTH ENTRY AND EXIT SIDES OF THE MILL.
**TEMPORARY SPECIFICATIONS SUBJECT TO REVISIONS****PHYSICAL INSPECTION TO VERIFY SPECIFICATIONS IS RECOMMENDED****PRICE QUOTED AS IS WHERE IS SUBJECT TO PRIOR SALE****ALL SPECIFICATIONS ARE SUBJECT TO VERIFICATION BY PURCHASER**
See this item on our web site: http://inv.mcmillanconroy.com/q/webinv/005249=x,14021

This machine is listed for sale by Machinery International Corp located in Woodbridge, Connecticut