Reference #32091
Four Corp PH-100-168 Seam Welder

FEATURES:
Miller SD-10D Side Beam Control
Powered Adjustable Bed Height
Precision Side Beam with Hardened Rounds
Pneumatic Mandrel Latch with Open/Close Switch
Swing Out Bars to Assist with Flat Sheet Loading

CAPACITY:
Welding Length ........................ 168"
Clamping Length ....................... 174"
Minimum Diameter Capacity (External) .. 14.5"
Maximum Diameter Capacity (External) .. 72"
Minimum Diameter for Interal Welds .... 60"
Approximate Shipping Weight ........... 11,680 Lbs.

EQUIPPED WITH:
Miller SD-10D Side Beam Control
Cyclomatic Arc Voltage Control with 7" Actuator
3" Wide Aluminum Claping Fingers with Copper Tips
Powered Adjustable Bed Height
Precision Side Beam with Hardened Rounds
Water Cooled Mandrel
Gas Purged Copper Backup Bar
Tape Switch on Base for Finger Clamping Actuation
Cable Management Festooning
Plate Alignment Device
Pneumatic Mandrel Latch with Open/Close Switch
Swing Out Bars to Assist with Flat Sheet Loading

NOTE:
Machine can be refurbished with New Controller for Additional Cost

This machine is listed for sale by Prestige Equipment located in Melville, New York