SPECIFICATIONS
CAPACITIES
SWING OVER BED: 36.8”
SWING OVER CROSS SLIDE: 29.1”
DISTANCE BETWEEN CENTERS: 91.5”
MAXIMUM TURNING DIAMETER: 25.5”
STANDARD TURNING DIAMETER: 14.7”
MAXIMUM TURNING LENGTH: 77.6”

TRAVELS
X-AXIS: 13.6”
Z-AXIS: 82.7”

SPINDLE
MAXIMUM SPINDLE SPEED: 1,500 RPM
NUMBER OF SPEED RANGES: 2
SPINDLE NOSE: JIS A2-15
THROUGH SPINDLE HOLE DIAMETER: 7.3”
MAXIMUM SPINDLE INDEXING ANGLE: 0.001°

TURRET
NUMBER OF TOOL STATIONS: 12
SHANK HEIGHT FOR SQUARE TOOL: 1-1/4”
SHANK DIAMETER FOR BORING BAR: 2-1/2”
TURRET INDEXING TIME: .04 SECONDS
MAXIMUM ROTARY TOOL SPINDLE SPEEDS: 3,000 RPM

FEED RATES
RAPID TRAVERSE RATE (X-AXIS): 787.4 IPM
RAPID TRAVERSE RATE (Y-AXIS): 944.9 IPM
RAPID TRAVERSE RATE (C-AXIS): 56 MIN-¹
JOG FEED RATE: 0 – 197 IPM

TAILSTOCK
TRAVEL: 78.7”
SPINDLE DIAMETER: 5.9”
TAPER HOLE OF TAILSTOCK SPINDLE: MT5
TAILSTOCK SPINDLE TRAVEL: 5.9”

MOTORS
SPINDLE DRIVE MOTOR (30 MIN/CONT): 40/30 HP
FEED MOTOR: 8/9.3 HP
ROTARY TOOL SPINDLE MOTOR (30 MIN/CONT): 12/10 HP
COOLANT PUMP MOTOR: .69 HP

GENERAL
FLOOR SPACE: 257.7” X 124.6” X 100.1”
WEIGHT (APPROXIMATELY): 33,000 LBS
ELECTRICS: 220 VOLT, 3 PH, 60 CYC
COOLANT TANK CAPACITY: 87.1 GALLONS

STANDARD FEATURES
OIL SPINDLE COOLING SYSTEM
12-STATION BOLT-TIGHTENED TURRET
COOLANT SYSTEM
MANUAL TYPE IN-MACHINE TOOL PRESETTER
BUILT-IN WORK LIGHT
LEVELING BLOCKS
CHUCK FOOT SWITCH
MT5 BUILT-IN TAILSTOCK CENTER

EQUIPPED WITH
FANUC F32iB (MAPPS IV) CONTROL
HIGH-OUTPUT SPINDLE
CHIP BLASTER JV-40 HIGH PRESSURE COOLANT SYSTEM
LNS TURBO RIGHT DISCHARGE, HINGE TYPE CHIP CONVEYOR
18” KITAGAWA BB218 LARGE THRU-HOLE POWER CHUCK
VARIABLE SPEED THREAD CUTTING
THREAD RE-CUTTING
LNS AUTOBLOCK K4 1-ZSW AUTOMATIC STEADY REST
(4) ROTARY TOOL HOLDERS
(1) FACE CUTTING POSITIONING BLOCKS
(3) OD CUTTING POSITIONING TOOLS

This machine is listed for sale by located in Bethlehem, Pennsylvania