New Dake Super Cut 315 Manual Cold Saw
PRODUCT FEATURES:
- Heavy-duty low production saw, comes with one standard HSS blade.
- Capable of near milled finish cuts.
- Large pivot point for extreme rigidity
- Heavy-duty gearbox for long dependable life. All steel and bronze gears. No plastic gears to break.
- CE Certified electronics. Low voltage hand control with dead man switch. Thermo over load protection, low voltage protection with emergency stop button. This all housed in a watertight electrical enclosure.
- Miters right and left up to 45 degrees, and all angles in between. Set-up is precise using the scribed scale on the vise pivot. Vise face can be adjusted close to the blade for maximum holding power. Vise incorporates an anti-burr arm, for burr free cuts.
- Hardened and serrated steel vise faces for sure clamping and long life.
- Vise is hand wheel adjustable and cam lever activated for repetitious clamping.
- Heavy gauge oversized steel base.
- Blade guard completely covers the blade.
- Stock stop gauge for repetitive cutting.
- Tool kit for quick blade changes.
- Complete CE approved English owner's manual, and blade pitch calculator.
- One gallon of coolant.
PRODUCT SPECIFICATIONS
Machine Type: Pivot head cold saw
Maximum Blade Size: 12-½ inches with 32 mm
Minimum Blade Size: 12 inches with 32 mm arbor
Spindle Speeds:
Single Phase = 1 speed
Three Phase = 2 speed
Minimum/Maximum spindle RPM:
Single Phase = 44 PRM
Three Phase = 22 RPM / 44 RPM
Head Feed: Manual
Vise: Manual, cam activated
Maximum Vise Opening: 4-5/8 inches
Miter Cutting Capabilities: 45° right / 45° left
Controls:
CE Certified 24-volt - Handle mounted trigger switch
Horsepower: 1.5 - 2.5 HP
Weight: 450 pounds
Work Height: 38-½ inches
Overall Height: 59 inches
Base Width: 26 inches
Depth: 36 inches
Lubricant:
Flood type unit built into the machine (Mechanical)
Voltage:
Available 120-volt single phase
Available 230-volt three phase
Available 460-volt three phase (external transformer) *Machine should be wired to main service by a qualified Electrician*
AMP:
20-amp service for 120-volt & 230-volts machines
16-amp service for 460-volt machines
Operating Temperature:
No special operating temperature level
CUTTING CAPACITIES
90°
Round: 3-5/8"
Square: 3-1/4"
Flat: 4-1/4" X 2-3/4"
45° Right
Round: 3-1/2"
Square: 3-1/8"
Flat: 3-1/4" x 2-3/4"
OPTIONS:
- Blade starter pack, Three HSS 12” blades (120, 180, and 280 tooth) Part# 79845
- 78” Loading Table – In-bound Part #301644
- 78” Unloading Table – Out-bound with scale and adjustable positive stop Part #301645
- Pneumatic vise Part# AAL3100L
FOR MORE INFORMATION: Call Rob at 973-497-7570