5000 Ton, Wean United 13" Oil Hydraulic Extrusion Press with Piercer

Still installed and under power in plant

Manufacturer - Wean United
Year - 1981
Oilgear upgrade - 2000

4-post design

Billet Heating -

2 - Billet Conveyor System

Billet Pre-heat furnaces
gas fired
blower fans
exhaust system
hydraulic load bar

Hydraulic System

2 - 2000 Ajax Magnethermic
Model Unit A, S/N H-2P150-C
Model Unit B, S/N H-2P150

Induction furnaces
Electric type
1,400-KW capacity
60-second cycle

Transfer conveyor

Cutler-Hammer programmable logic control
Control panel S/N H-2P15-J

52-Gallons per minute water flow

Input
550/605 volts
1792-KVA
2,175 maximum amperes

Output
1,250 volts
3,313-KVA
2,650 maximum amperes
1,600 KW

Wean United Extrusion Press -

S/N 37866-13
Equipment # 8515
5,000 ton capacity
Oil hydraulic

507 ton advance piercer
320 ton return piercer

800 ton advance slide rams
320 ton return slide rams

75" main and side rams stroke

41" piercer ram stroke

18" container shifting rams stroke

13" per second rapid advance main ram speed

11.8" per second return main ram speed

2" per second +/- .6" (typical) extrusion speed

9.8" per second advance piercer speed
10.8" per second return pierder speed

6.5" opening container speed
4.7" closing container speed

8.8" minimum billet diameter
13.7" maximum billet diameter

29.5" billet length

6.8" outside diameter maximum extrusion

33.8" container length

107 HP container heater
422 HP main pumps
25 HP ceiling pumps
20 HP saw


Control Panel - Upgraded by Oilgear, 2000
Allen Bradley Controls, 2000
Oilgear automation systems programmable logic control

Press Runout -

Cooling trough
Runout table
Water and soluble oil
Manual unload

Tube cutoff saw, 14" blade

Runout table
Scrap dump section
Hold bins w/ crane transfer
Tube holding bin

Hydraulic System Room, including but not limited to -

7 - Rex Roth Pumps
315 KW
50 cycle
500 volts
1475 RPM

7 - Asea pumps - 140 HP motor, skid mounted
2 - Asea pumps - 40-HP motor
2 - Asea pumps - 15-HP motor
1 - Pump, hydraulic fluid, w/ (2) 30-HP motors
1 - 2004 Husky Pro Model VT631402AJ air compressor S/N 1/29/04-24107,

Reciprocating type, 7-HP motor, 60-gallon capacity, 135-PSI, vertical tank

mounted
w/ 2000 Hal-Tank fabricators model CVBT200S air receiving tank, S/N 00-1860,

approximately 200-gallon capacity, vertical type, skid mounted, assorted

pumps,
centrifugal type


*ALL SPECIFICATIONS ARE SUBJECT TO VERIFICATION BY PURCHASER**

PRICE NET ON LOCATION

This machine is listed for sale by National Machinery Exchange Inc located in Newark, New Jersey